Usado tester en Japón

HIGH VOLTAGE INSULATION TESTER IR5051

• Fabricante: HIOKI E.E

Measurement parameters: • Insulation resistance • PV insulation resistance • Leakage current • Voltage • Capacitance (DD function) | Max. rated voltage to terminals: 1000 V AC, 2000 V DC | Max. rated voltage to g...

HIGH VOLTAGE INSULATION TESTER IR5050

• Fabricante: HIOKI E.E

Measurement parameters: • Insulation resistance • Leakage current • Voltage • Capacitance (DD function) | Max. rated voltage to terminals: 1000 V AC, 2000 V DC | Max. rated voltage to ground: 1000 V (CAT IV), 600...

EARTH TESTER FT6041

• Fabricante: HIOKI E.E

measurement parameters: • Ground resistance measurement: 4-pole method, 3-pole method, 2-pole method, MEC function, clamp-on measurement (two clamps) • Soil resistivity measurement: 4-pole method • Low-resistanc...

PARTIAL DISCHARGE DETECTOR ST4200

Detection method: Discharge current detection using a CT and digital filter in compliance with IEC 61934 Edition 2.0 and IEC 60034-27-5 | Test frequency range (applied voltage): 45 Hz to 1.1 kHz | Charge quantity...

SHORT-OPEN TESTER FA1221

• Fabricante: HIOKI E.E

Number of test points: 128 pins (during 4-terminal measurement, up to 32 sets) | Number of test steps: Round-robin short/open : 128 pins Component data : Max. 10000 steps Charge data : 40 sets Pin contact data : ...

IMPULSE WINDING TESTER ST4030A

• Fabricante: HIOKI E.E

Measurement items: • Quantification (LC value, RC value) of the response waveform obtained when impulse voltage is applied, pass / fail judgment • Waveform judgment using AREA value, Flutter, Laplacian etc. • Equ...

IN-CIRCUIT TESTER FA1220-11

• Fabricante: HIOKI E.E

Number of test points: Standard: 0 pins (scanner boards optional) Max. 2048 pins (expandable in blocks of 128 pins)* * The maximum number of active pins for each test type depends on the total number of scanner b...

IN-CIRCUIT TESTER FA1220-02

• Fabricante: HIOKI E.E

Number of test points: Standard: 0 pins (scanner boards optional) Max. 2048 pins (expandable in blocks of 128 pins)* * The maximum number of active pins for each test type depends on the total number of scanner b...

INSULATION TESTER IR4053

• Fabricante: HIOKI E.E

Rated output voltage: 50 V DC | Effective maximum indicated value: 100 MΩ | Measuring range/ accuracy: 0.200 to 500 MΩ / ±4% rdg. 501 to 2000 MΩ / ±8% rdg. | Other measuring range / accuracy: 0 to 0.199 MΩ / ±2%...

EARTH TESTER FT6031-50

• Fabricante: HIOKI E.E

Measurement system: Two-electrode method/three-electrode method (switchable) | Measurement range: 20 Ω (0 Ω〜20.00 Ω) | Accuracy: ±1.5% rdg ±8 dgt | Earth voltage: 0〜30.0 V rms Accuracy: ±2.3% rdg ±8 dgt (50 Hz/60...

ANALOG EARTH TESTER FT3151

• Fabricante: HIOKI E.E

Measurement system: AC potentiometer method, Three-electrode method/ two-electrode method (switchable) Measuring frequency: 575 Hz/ 600 Hz Measurement current: Three-electrode method: 15 mA rms or less; Two-elect...

ANALOG MΩ HiTESTER IR4016

• Fabricante: HIOKI E.E

Rated output voltage: 500 V DC | Effective maximum indicated value: 100 MΩ | Accuracy 1st effective measuring range: ±2 % of scale length, 0.1 M to 50 MΩ | Lower limit resistance: 0.5 MΩ (measurement resistance v...

ANALOG MΩ HiTESTER IR4018

• Fabricante: HIOKI E.E

Rated output voltage: 1000 V DC | Effective maximum indicated value: 2000 MΩ | Accuracy 1st effective measuring range: ±2 % of scale length, 2 M to 1000 MΩ | Lower limit resistance: 1 MΩ (measurement resistance v...

ANALOG MΩ HiTESTER IR4017

• Fabricante: HIOKI E.E

Rated output voltage: 500 V DC | Effective maximum indicated value: 1000 MΩ | Accuracy 1st effective measuring range: ±2 % of scale length, 1 M to 500 MΩ | Lower limit resistance: 0.5 MΩ (measurement resistance v...

ANALOG MΩ HiTESTER 3490

• Fabricante: HIOKI E.E

Rated output voltage: 250 V DC | Effective maximum indicated value: 100 MΩ | Accuracy 1st effective measuring range: ±2 % of scale length 0.05 to 50 MΩ | Lower limit resistance: 0.25 MΩ | Overload protection: 660...